Description
The Vapor Storm Eco Mod is a 90W 18650 Mech Mod offers you a unique look full of colour patterns and graffiti that you will not find elsewhere. Not only that, but each mod within a “theme” is different to all the other mods in the same “theme”, they will share the same pattern and colours, but they will appear on different places on the mod. The cost-effective Vapor Storm Eco Mod is made of ABS plastic and is so lightweight and nice in the hand. The mod runs on a single 18650 battery (not included), which is inserted behind the magnetic panel. The battery can be charged directly in the device via the micro USB port, so you will not need an external charger. Simple design is complemented by simple use. The Vapor Storm Eco Mod has no display or control buttons and does not need to be set in any way. Being a mechanical mod it works on the principle of the direct output voltage of the battery. The more charged the battery is, the more voltage it delivers to the coil. The voltage range is between 3.3V and 4.2V. The Vapor Storm Eco Mod mod reaches a maximum power of 90W. The only button is used to switch the device on, off, and to heat the coil. Finally, the Mod is equipped with all the necessary protections: Reverse Polarity, Short Circuit Protection and Low Voltage Cut-off (3.3V). If you are unfamiliar with mechanical mods, please read up on them before you consider buying! Know about Battery Safety and Ohm’s Law! Vapor Storm Eco Mod Features: Dimensions: 82 x 40 x 25mm Output power: max. 90W Output voltage: 3.3V-4.2V Supported modes: direct output voltage Supported resistance: min. 0.09Ω Battery: 18650 (at least 25A) – not included Charging: micro USB port (5V / 0.75A) Thread: 510 and spring-loaded contact Resistance range: 0.09 – 3.50 ohms Material: ABS Reverse Polarity Protection Short circuit protection Low battery voltage cut-off (3.3 Volts) What’s in the box: Vapor Storm Eco Mod Micro USB cable User Manual Authentication code
